POWER SUNROOF — IF EQUIPPED
SINGLE PANE POWER SUNROOF — IF EQUIPPED
The power sunroof switches are located on the overhead console between the courtesy/ reading lights.
1 — Opening/Closing Sunroof 2 — Venting Sunroof
Opening And Closing The Sunroof
Push the switch rearward and release it within one-half second and the sunroof will open automatically from any position. The sunroof will open fully and stop automatically.
Push the switch forward and release it within one-half second and the sunroof will close automatically from any position. The sunroof will close fully and stop automatically.
During Express Open or Express Close operation, any other movement of the sunroof switch will stop the sunroof.
To open the sunroof, push and hold the switch rearward to full open.
To close the sunroof, push and hold the switch in the forward position.
Any release of the switch during open or close operation will stop the sunroof movement. The sunroof will remain in a partially opened position until the switch is operated and held again.
If the sunshade is in the closed position when Express or Manual Open operation is initiated the sunshade will automatically open to the half open position prior to the sunroof opening.
This feature will detect an obstruction in the opening of the sunroof during Express Close operation. If an obstruction in the path of the sunroof is detected, the sunroof will automatically retract. Remove the obstruction if this occurs.
If three consecutive sunroof close attempts result in Pinch Protect reversals, Pinch Protect will disable and the sunroof must be closed in Manual Mode.
Push and release the Vent button within one half second and the sunroof will open to the vent position. This is called “Express Vent”, and it will occur regardless of sunroof position.
During Express Vent operation, any other actuation of the switch will stop the sunroof.
The sunshade can be opened manually. However, the sunshade will open automatically as the sunroof opens.
NOTE: 2
The sunshade cannot be closed if the sunroof is open.
The power sunroof switch will remain active for up to approximately 10 minutes after the ignition switch is placed in the OFF position.
Opening either front door will cancel this feature.
Ignition Off time is programmable through the Uconnect system page 237.
Use only a non-abrasive cleaner and a soft cloth to clean the glass panel. Periodically check for and clear out any debris that may have collected in the tracks.
DUAL PANE POWER SUNROOF — IF EQUIPPED
The power sunroof switches are located on the overhead console between the courtesy/ reading lights.
1 — Opening/Closing Sunroof 2 — Venting Sunroof
3 — Opening/Closing Sunshade
The sunroof has two programmed automatic stops for the sunroof open position; a comfort stop position and a full open position. The comfort stop position has been optimized to minimize wind buffeting.
Push the switch rearward and release it within one-half second and the sunroof will open automatically from any position. The sunroof will open fully and stop automatically.
Push the switch forward and release it within one-half second and the sunroof will close automatically from any position. The sunroof will close fully and stop automatically.
During Express Open or Express Close operation, any other movement of the sunroof switch will stop the sunroof.
To open the sunroof, push and hold the switch rearward to full open.
To close the sunroof, push and hold the switch in the forward position.
Any release of the switch during open or close operation will stop the sunroof movement. The sunroof will remain in a partially opened position until the switch is operated and held again.
If the sunshade is in the closed position when Express or Manual Open operation is initiated the sunshade will automatically open to the half open position prior to the sunroof opening.
Opening And Closing The Power Sunshade The sunshade has two programmed positions: half open and full open positions. When
operating the sunshade from the closed
position, the sunshade will always stop at the half open position regardless of express or manual open operation. The switch must be actuated again to continue on to full open position.
If the sunroof is open or vented, the sunshade cannot be closed beyond the half open position. Pushing the sunshade close switch when the sunroof is open/vented and the sunshade is at half open position will first automatically close the sunroof prior to the sunshade closing.
Push the sunshade switch rearward and release it within one-half second, the sunshade will open to the half open position and stop automatically. Push and release the switch again from the half open position and the sunshade will open to the full open position and stop automatically.
Push the sunshade switch forward and release it within one-half second and the sunshade will close automatically.
During Express Open or Express Close operation, any other actuation of the sunroof switches will stop the sunshade in a partially open position.
Push and hold the sunshade switch rearward, the sunshade will open to the half open position and stop automatically. Push and hold the
sunshade switch again and the sunshade will 2
open to the full open position.
Push and hold the switch forward and the sunshade will close and stop at full closed position.
Releasing the switch while the sunshade is in motion will stop the sunshade in a partially open position.
This feature will detect an obstruction in the opening of the sunroof during Express Close operation. If an obstruction in the path of the sunroof is detected, the sunroof will automatically retract. Remove the obstruction if this occurs.
If three consecutive sunroof close attempts result in Pinch Protect reversals, Pinch Protect will disable and the sunroof must be closed in Manual Mode.
Push and release the Vent button within one half second and the sunroof will open to the vent position. This is called “Express Vent” and it will occur regardless of sunroof position.
During Express Vent operation, any movement of the switch will stop the sunroof.
If the sunshade was not already open, it will automatically open prior to the roof opening to the vent position.
The power sunroof switch will remain active for up to approximately 10 minutes after the ignition switch is placed in the OFF position.
Opening either front door will cancel this feature.
Ignition Off time is programmable through the Uconnect system page 237.
Use only a non-abrasive cleaner and a soft cloth to clean the glass panel. Periodically check for and clear out any debris that may have collected in the tracks.
Download Manual